Delta TP305 Instruction Manual download pdf (Page 8)

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE

ENTIRE INSTRUCTION MANUAL.

Fig. 4 Fig. 5

RAISING AND LOWERING HANDLE

Attach the raising and lowering handle (A) Fig. 4 to the shaft (B) and fasten in place with M5x20mm screw (C). NOTE:

Ensure that the flats of the handle and the flats on the shaft are aligned. Flip handle (A) upward as shown in Fig. 5.

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from

all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,

gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household

floor paste wax.

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE - 30 minutes

Fig. 6

LOWERING EXTENSION TABLES

The infeed and outfeed extension tables (A) Fig. 6 are

shipped attached to the machine in the raised position.

Lower the tables (A) on both sides of the planer

(Fig. 6). The top surface of extension tables should be

level with the planer table. To check and adjust, refer to

the section “LEVELING EXTENSION TABLES” in this

manual.

* 5mm wrench (included)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

No comments

Delta TP305 Instruction Manual Page 8