Delta TP305 Instruction Manual download pdf (Page 9)

Fig. 7

Fig. 8

Fig. 9

CUTTERHEAD GUARD

1. Attach the cutterhead guard (A) Fig. 7 to the planer

by inserting the end of the guard over the top of the

cutterhead. Place the slots in the cutterhead guard

2. Fasten cutterhead guard (A) Fig. 8 to planer using

two knobs, one of which is shown at (D).

MAKE SURE THAT THE CUTTERHEAD

GUARD IS PROPERLY SECURED

WITH THE KNOBS BEFORE

OPERATING THIS MACHINE.

FASTENING PLANER TO

SUPPORTING SURFACE

During operation, if there is any tendency for the planer

to tip over, slide or “walk” across the supporting surface,

the planer must be secured to the supporting surface.

Four holes (two of which are shown at (A) Fig. 9) are

provided for this purpose.

OPERATION

STARTING AND STOPPING PLANER

1. The on/off switch (A) Fig. 10 is located on the front of the planer motor. To turn the machine “ON,”

move the switch up to the “ON” position.

2. To turn the machine “OFF”, move the switch (A) down to the “OFF” position.

MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION BEFORE PLUGGING IN THE POWER

CORD. IN THE EVENT OF A POWER FAILURE, MOVE THE SWITCH TO THE “OFF” POSITION. AN

ACCIDENTAL START-UP CAN CAUSE INJURY.

LOCKING SWITCH IN THE “OFF” POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent

unauthorized use. To lock the switch, grasp the switch toggle (D) Fig. 11 and pull it out of the switch (A). With the

switch toggle (D) removed, the switch will not operate. However, should the switch toggle be removed while the saw

is running, the machine can be turned “OFF,” but cannot be restarted without re-inserting the switch toggle (D).

OPERATIONAL CONTROLS AND ADJUSTMENTS

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta TP305 Instruction Manual Page 9