Delta ts200ls Instruction Manual download pdf (Page 24)

Fig. 49

Fig. 50

Kerf should be

about 1/4" apart.

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call

the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

Further information on the safe and proper

operation of table saws is available in the Delta

“Getting the Most Out of Your Table Saw” How-

To Book, Catalog No. 11-400. Additional

Information on table saw safety, including a

table saw safety video, is available from the

following:

POWER TOOL INSTITUTE

1300 Sumner Avenue

Cleveland, OH 44115-2851

www.powertoolinstitute.com

Fig. 49, illustrates dimensions for making a typical featherboard. The material which the featherboard is constructed of,

should be a straight piece of wood that is free of knots and cracks. Featherboards are used to keep the work in contact

with the fence and table, as shown in Fig. 50, and help prevent kickbacks. Clamp the featherboards to the fence and

table so that the leading edge of the featherboards will support the workpiece until the cut is completed. An 8″ high

flat board can be clamped to the rip fence and the featherboard can be clamped to the 8″ high board.

Use featherboar

ds for all non “thru-sawing” operations where the guard and splitter assembly must be

removed. Always replace the guard and splitter assembly when the non thru-sawing operation is completed.

CONSTRUCTING A FEATHERBOARD

1 2 ... 19 20 21 22 23 24 25 26 27

No comments

Delta ts200ls Instruction Manual Page 24