Delta BS100 Instruction Manual download pdf (Page 16)

Fig. 37A

WRENCH STORAGE

The 3mm and 4mm wrenches (A) supplied with your

band saw can be stored inside the wheel cover as

shown in Fig. 37A.

CHANGING BLADES

To change blades:

DISCONNECT MACHINE FROM POWER SOURCE.

1. Press in door latches (A) Fig. 34, and open door (B) as shown.

2. Loosen two screws (C) Fig. 35, and remove blade guard (D).

3. Release tension on the band saw blade by turning tension knob (E) Fig. 34 counterclockwise.

4. Remove table alignment screw (F) Fig. 36.

5. Slip the blade off both wheels and guide it out through the slot in the table.

6. Check the new blade to make sure that the teeth will point down toward the table when installed. IF NOT,

CAREFULLY TURN BLADE INSIDE OUT.

7. Place the new blade onto wheels and adjust blade tension, blade guides and tracking as described prev-iously in

this manual.

8. Replace blade guard, which was removed in STEP 2, and table alignment screw which was removed in

STEP 4.

9. Close door (B) Fig. 34, before operating saw.

Fig. 34

Fig. 35

Fig. 36

Fig. 37

DUST CHUTE

A dust collection system can be attached to the 1¾"

O.D. dust chute (A) Fig. 37.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

No comments

Delta BS100 Instruction Manual Page 16