INSTRUCTIONS30" Fence and Rail System(Model 36-648)PART NO. 912859 - 10-20-03Copyright © 2003 Delta MachineryTo learn more about DELTA MACHINERY
10NOTES
11PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof P
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder
2Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
3ASSEMBLYFRONT GUIDE RAIL ANDSWITCH ASSEMBLY1. Loosely assemble front guide rail (A) Fig. 3, to thefront of the saw table. Align the two holes (B) and
4REAR RAIL1. Align holes in saw table and extension wings withfour holes in rear guide rail (J) Fig. 6. NOTE: Flat edge ofrear guide rail (J) will fac
56. Once the rip fence is aligned with the miter gageslot, raise the saw blade (E) Fig. 11, to its highestposition, as shown. Slide rip fence (B) agai
6Fig. 14KKAGB4. Using a square (G) Fig. 14, check to see if the ripfence (B) is perpendicular to the saw table and that therip fence body is level wit
7RIPPINGA RIP FENCE SHOULD ALWAYS BEUSED FOR RIPPING OPERATIONS. NEVERPERFORM A RIPPING OPERATION FREE-HAND. Ripping is the operation of making a leng
8MAINTENANCEFENCE LUBRICATION1. Apply paste wax to fence and guide tube sliding sur-faces weekly. 2. Apply grease to cam lock (A) Fig. 21, and cam foo
9PUSH STICKMAKE FROM 1/2" OR 3/4"WOOD OR THICKNESSLESS THAN WIDTH OFMAT’L. TO BE CUTCUT OFF HERE TOPUSH 1/4" WOODCUT OFF HERE TOPUSH 1/
Comments to this Manuals