Delta 36-648 User Manual download pdf (Page 4)

REAR RAIL

1. Align holes in saw table and extension wings with

four holes in rear guide rail (J) Fig. 6. NOTE: Flat edge of

rear guide rail (J) will face upward. Insert a 3/8-16x1" hex

head screw (A) Fig. 43, through hole in rear guide rail and

hole in saw table. Place a 3/8" flat washer (B) Fig. 6, and

a 3/8" lock washer (C), onto the hex head screw. Thread

a 3/8-16 hex nut (D), onto the hex head screw. Repeat

this process for the three remaining holes in the rear

guide rail and the saw table and extension wings.

Fig. 6

2. Before tightening mounting hardware, using an

adjustable square (F) Fig. 7, or a ruler, check to make

certain the rear guide rail (J) is parallel with the saw table

and extension tables.

Fig. 7

RIP FENCE TO GUIDE RAILS

1. Insert end cap (A) Fig. 8, into back of rip fence (B).

2. With the fence handle (A) Fig. 9, in the raised

position, place the rip fence (B) onto the rear guide rail

of the guide rail as shown.

Fig. 8

Fig. 9

3. Lower the front of rip fence (B) Fig. 9, onto the front

guide rail (L).

4. Lock the rip fence (B) Fig. 9, on the guide rails by

pushing down handle (A).

5. Slide rip fence (B) Fig. 9, against one edge of the

miter gage slot (C) as shown. Clamp the fence onto the

guide rail by pushing down on lock handle (A). The edge

of the fence (B) Fig. 9, should line up so it is parallel with

the edge of the miter gage slot. If an adjustment is

necessary, pull up on lock handle (A) to loosen fence,

tighten or loosen either of two screws (D)

Fig. 10, as necessary until rip fence (B) Fig. 9, lines up

with the miter gage slot. NOTE: Cursor has been

removed for clarity.

Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta 36-648 User Manual Page 4