Delta 14-070 Instruction Manual download pdf (Page 8)

7. Assemble table raising and lowering handle (M) Fig.

8, to shaft on table bracket and tighten set screw in han-

dle against flat on shaft.

8. Thread table bracket lock screw (O) Fig. 8, into hole

in table bracket, as shown.

9. Place the drill press head onto the column as far

as it will go. After the drill press spindle is aligned with

the table and base, tighten the two set screws (P) Fig.

10. Thread the three pinion shaft handles (R) Fig. 10,

into the three tapped holes located in the pinion shaft

hub,as shown.

Fig. 8

Fig. 9

Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

No comments

Delta 14-070 Instruction Manual Page 8