Delta 14-070 Instruction Manual download pdf (Page 9)

11. IMPORTANT: Make certain the bottom of

spindle (S) Fig. 11, and tapered hole (T) in chuck

are clean and free of any grease, lacquer or rust

preventive coatings. NOTE: Household oven

cleaner can effectively remove any substance

from the spindle and chuck; however, carefully

follow the manufacturer’s safety rules concerning

its use.

12. IMPORTANT: OPEN THE CHUCK JAWS

AS WIDE AS POSSIBLE, MAKING SURE THE

CHUCK JAWS ARE UP INSIDE CHUCK.

13. Hold chuck (U) Fig. 12, and carefully drive

chuck onto the spindle with a block of wood and

a hammer, or a mallet (V), as shown. This will seat

the chuck properly on the spindle. IMPORTANT:

To avoid damage to the chuck NEVER drive the

chuck onto the spindle with a metal hammer.

FASTENING DRILL PRESS

TO A SUPPORTING SURFACE

PERMANENT MOUNTING

If your drill press is to be used in one permanent

location, the drill press base must be secured to

the supporting surface with fasteners through the

two mounting holes,

(A) Fig. 12A, in the drill press base (B).

MOUNTING YOUR DRILL PRESS TO A PLYWOOD BASE

If you do not fasten your drill press in a permanent manner, the drill press must be fastened to a ply-

wood mounting board to prevent the drill press from tipping over during normal use. Use a good

grade of plywood with a minimum 3/4" thickness. Do not make the mounting board from particle

board since particle board can unexpectedly break.

Fig. 11

Fig. 12

Fig. 12A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

Delta 14-070 Instruction Manual Page 9