Delta GR150 Operations Instructions download pdf (Page 8)

Page 6

1285-00

60708-153

The generator set can be lifted with properly rated chains or cables

along with the use of spreader bars. The spreader bars should be

long enough so that the lift cables or chains do not come into con-

tact with the generator set. Use of commercially available lifting

fixtures may also be used. Always be sure that the equipment is

properly rated for the weight of the generator. Failure to do so can

cause damage to the generator, injury to personnel or even death.

Depending on generator set size and configuration, the exhaust

system may ‘ship loose’ with the generator set for installation on

site. The muffler and its attaching brackets must be mounted on

top of the generator housing prior to operating the engine

generator set.

INSTALLATION

***************

***** WARNING ****

***************

PERSONAL INJURY - Before proceeding with the installation,

be sure the DSE7X10 is in the "stop" position. Before

proceeding with the installation, be sure the Generator MLCB

(Main Line Circuit Breaker) is in the ‘OFF’ position and the

unit starting battery is disconnected.

GENERAL INFORMATION

These engine/generator sets are generally supplied as weather

enclosed packages for quick installation on an outdoor concrete

pad. They are also available as open skid mounted units for indoor

installation in a building or protective enclosure supplied by the

installer. The factory weather enclosures are available as standard

or acoustical housing intended for outdoor installation only. Factory

weather enclosed units are not intended to be used indoors and

no support is available to assist in re-engineering finished

packaged units.

All versions must be bolted to a solid base for proper operation. A

properly designed concrete pad is necessary for stationary opera-

tion. A substantial DOT certified trailer is required for mobile appli-

cations. Consult a qualified, licensed electrician or contractor to

install and wire this Generator Set. The installation must comply

with all national, state, and local codes.

Before beginning the installation process, recheck the voltage,

phase and amperage rating of the Generator Set and ATS (Auto-

matic Transfer Switch). Be certain they can handle the intended load

and are compatible with the entrance voltage, phase and current

ratings. Plans for installation should be prepared with proper

attention to mechanical and electrical engineering detail to assure a

satisfactory system installation.

The information in this manual is offered only as a guide to finalizing

your installation plans.

NOTICE

For full service switching of the entire load, the ATS must be ‘SE’

(Service Entrance) rated or must have a properly rated fusible

disconnect installed before the ATS to protect the contacts

ENGINE GENERATOR SET MOUNTING

The unit’s main frame must be bolted solidly to a 4 to 6 inch thick

cement pad. The engine-generator is mounted on a sub-frame

which is attached with special shock mounts to the main frame.

This allows the engine-generator free movement without affecting

the control panel which is mounted on the main frame.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Delta GR150 Operations Instructions Page 8

Comments to this Manuals