Delta SA446 Instruction Manual download pdf (Page 8)

Fig. 8

Fig. 6

Fig. 7

Fig. 5

ASSEMBLING BELT

AND PULLEY GUARD

Assemble the belt and pulley guard (A) Fig. 5, to the

machine base using the two M6x1x30mm cheese head

screws (B), as shown.

ASSEMBLING

SANDING DISC PLATE

1. Back the 1/4-20x1/4" hex socket set screw (A) Fig.

6, out of the hole, just enough so that the set screw is not

extending into hole (B) Fig. 6, in the sanding plate.

2. Slide sanding disc plate (B) Fig. 7, on drive shaft (C)

making sure flat on drive shaft is aligned with set screw

(A) in hub of plate (B). Slide plate (B) onto shaft (C) until

plate surface and shaft are nearly flush. Shaft must not

extend out past surface of plate.

3. Insert the 1/8" hex wrench (D) Fig. 8, down through

slot in the back of belt and pulley guard and tighten set

screw against flat on shaft.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

Delta SA446 Instruction Manual Page 8