Delta 36-979 Instruction Manual download pdf (Page 17)

9. Place a ¼" flat washer and then a spacer (P) onto

the ¼-20x1-1/2" hex head screw (L) Fig. 37. Then

thread a ¼-20 Hex Nut (Q) Fig. 37, onto the screw

post until it tightens the spacer onto the pulley guard

(I) Fig. 37.

10. Align the hole (S) Fig. 40 in the belt guard (R) with

the ¼-20x1 ½" hex head screw (L) Fig. 37. Place the

screw through the hole in the belt guard (R) Fig. 40.

Place a ¼" External Tooth Lockwasher onto the hex

head screw and thread a 1/4-20 Wing Nut onto the

hex head screw, and tighten securely.

MAKE CERTAIN THE BELT GUARD

DOES NOT TOUCH THE DRIVE BELT

OR MOTOR PULLEY.

CONNECTING MOTOR CORD

TO SWITCH ASSEMBLY

Insert the pronged motor plug (A) Fig. 41, into the female

receptacle (B) of switch-to-motor cord, which is located

inside the saw housing.

MAKE SURE THE CORD RUNNING

FROM THE SWITCH TO THE FEMALE

END (B) FIG. 41 IS CLAMPED TO THE INNER WALL OF

THE SAW UNIT AND WILL NOT COME IN CONTACT

WITH THE BLADE OR ANY MOVING PARTS.

Fig. 42 illustrates the motor cord connected to the

switch assembly.

REMOVING MOTOR FOR

TRANSPORT

To remove the motor for transport through narrow

doorways, first unplug the motor cord from the switch

cord. Then, while holding the motor, press in on pins

(G) Fig. 32 and lower motor off of bracket (B) Fig. 33.

Fig. 40

Fig. 41

Fig. 42

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 36 37

No comments

Delta 36-979 Instruction Manual Page 17