Delta 36-979 Instruction Manual download pdf (Page 30)

BEVEL RIPPING

Bevel ripping (as shown in Fig. S12) is the same as

ripping except the bevel angle is set to an angle other

than 0 degrees.

WHEN POSSIBLE, PLACE THE FENCE

ON THE RIGHT SIDE OF THE BLADE

SO THAT THE BLADE IS TILTED AWAY FROM THE

FENCE AND HANDS. KEEP HANDS CLEAR OF THE

BLADE AND USE A PUSHSTICK TO FEED THE

WORKPIECE IF THERE IS LESS THAN 6” BETWEEN

THE FENCE AND THE BLADE.

USE CAUTION WHEN STARTING THE

CUT TO PREVENT BINDING OF THE

GUARD AGAINST THE WORKPIECE.

NOTE: In Fig. S11, the guard and splitter have been

removed for clarity. Guard and splitter should be

used when ripping.

5. For longer pieces, use one or more pushsticks to

avoid placing your hands between the fence and the

blade. Always use care to avoid binding narrow strips

between the anti-kickback pawls and the splitter.

NOTE: Some special operations (when using the

moulding cutterhead) require the addition of an

auxiliary wood facing to the fence, as explained in

the section “USING AUXILIARY WOOD FACING,”

and use of a push stick.

Fig. S12

Fig. S13

Fig. S14

USING MOULDING CUTTERHEAD

Moulding is cutting a shape on the edge or face of the

work with a special moulding cutterhead.

The moulding head consists of a cutterhead in which can

be mounted various shapes of steel knives, (Fig. S13).

Each of the three knives in a set is fitted into a groove

in the cutterhead and securely clamped with a screw.

The knife grooves should be kept free of sawdust which

would prevent the cutter from seating properly.

FOR CERTAIN CUTTING OPERATIONS

(DADOING AND MOULDING) WHERE

THE WORKPIECE IS NOT CUT COMPLETELY

THROUGH, THE BLADE GUARD AND SPLITTER

ASSEMBLY CANNOT BE USED. LOOSEN SCREWS AT

(G) AND (H) FIG. S14. LIFT UP AND REMOVE BLADE

GUARD AND SPLITTER ASSEMBLY (W).

USE PUSHSTICKS, HOLD-DOWNS,

JIGS, FIXTURES, OR FEATHERBOARDS

TO HELP GUIDE AND CONTROL THE WORKPIECE

WHEN THE GUARD CANNOT BE USED.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37

Comments to this Manuals

No comments

Delta 36-979 Instruction Manual Page 30

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-979