Delta 36-979 Instruction Manual download pdf (Page 18)

BLADE GUARD AND SPLITTER

ASSEMBLY AND ALIGNMENT

1. Fasten the rear splitter mounting bracket (A) Fig.

43, to the rear trunnion. Align the two holes in the

rear splitter mounting bracket (shown at B) with the

two holes in the trunnion. Place a ¼" Lock Washer

onto a ¼ -20 x ¾" Hex Head Screw, place a ¼"

Flat Washer onto the hex head screw, insert the

hex head screw through the hole in the rear splitter

mounting bracket and thread the hex head screw

into the rear trunnion. Repeat this process for the

remaining hole. Do not completely tighten the two

screws (B) at this time.

2. Raise saw arbor to its highest position.

Fig. 43

Fig. 44

3. Remove screw and large washer (C) Fig. 44 from the

inside splitter mounting bracket.

4. Using a straight edge, check to see if the top and

bottom of the inside splitter bracket (D) Fig. 45 is

aligned with the inner arbor flange (E), as shown.

Fig. 45

Fig. 46

5. If alignment is necessary, loosen the two screws

(F) Fig. 46, align bracket (D) with the arbor flange

and tighten screws (F).

6. Loosely assemble large washer and screw (C) Fig. 46

to the inside splitter bracket. This screw and washer

was removed in STEP 3.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

No comments

Delta 36-979 Instruction Manual Page 18