Delta RS830 Instruction Manual download pdf (Page 16)

4. Place a square (D) Fig. 32 on the table and against the

saw blade. See if the blade is square with the table.

NOTE: The square should rest between two teeth of the

saw blade.

5. To adjust, tighten the bevel clamp lever (C) Fig. 31.

6. Remove the screw, flat washer, and pointer (E) Fig. 31.

7. Remove the two screws (F) Fig. 31 and the bevel scale

plate (H) Fig. 32 with the index knob (A).

8. Loosen the four hex screws (G) Fig. 33. Tilt the motor

until the saw blade is flush with the square. Tighten the

four hex screws (G).

9. Replace the bevel scale plate (H) Fig. 33 with the bevel

index release knob (A), two screws, and pointer that

were removed earlier.

NOTE: Adjust the pointer to “zero” on the bevel index scale.

ADJUSTING IN/OUT RIP SCALE

1. Loosen the yoke clamp handle (A) Fig. 34. Release

the yoke index by pressing the release lever (B) up or

down. Rotate the cuttinghead (C) to the in-rip position

(Fig. 34). Tighten yoke clamp handle (A).

2. Position the fence (D) Fig. 34 at the rear of the table.

3. Loosen the cuttinghead clamp knob (C) Fig. 34. Slide

the cuttinghead to the rear of the track arm until the

saw blade (F) is flush against the fence (D).

4. Tighten the cuttinghead clamp knob. Adjust the pointer

(H) Fig. 34 to the “zero” mark on the lower scale (J)

by loosening the screw (K). Tighten the screw when

finished.

Fig. 32

Fig. 33

Fig. 34

1. Attach the inside (thick) arbor flange (A) Fig. 35 to the

arbor shaft with the recessed side of flange (A) facing

out.

ATTACHING THE BLADE AND BLADE GUARD

NOTE: Use only 10" blades with 5/8" arbor holes and

rated for 5000 rpm or higher.

Fig. 35

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

No comments

Delta RS830 Instruction Manual Page 16