Delta RS830 Instruction Manual download pdf (Page 9)

1. The saw was packed at the factory with support blocks

(A) Fig. A1 under the cutter-head (B) and the track arm

(C). Shipping boards (D) Fig. A1 were fastened to saw

base (G). To prevent damage during shipment, the

track arm elevating knob (H) was removed from the

lever (E). Insert the post of the knob (H) Fig. A2 through

the hole in the lever (E). Attach the E-ring (K) to the slot

in the post.

2. You can remove the support blocks (A) Fig. A1 by rotating

the track arm elevating knob (H) clockwise. Remove the

shipping boards (D) by taking out the hold-down screws

(not shown), located inside the saw base. Discard the

support blocks (A) and the shipping boards (D).

3 The saw with the support blocks and shipping boards

removed is illustrated in Fig. A3.

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from

unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.

Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your

machine.

After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.

Fig. A1

Fig. A3

Fig. A2

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes approximately 2-3 hours.

7/8" Open End - 1/2" Box Wrench (included)

7/8" x 1/2" Box Wrench (included)

1/2” and 3/8” Wrenches, Open End or Socket

Flathead Screwdriver

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and remov-

ing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 87 88

No comments

Delta RS830 Instruction Manual Page 9