Delta Sidekick 36-210 Instruction Manual download pdf (Page 13)

Fig. 28

Fig. 27

Fig. 26

Fig. 25

4. If an adjustment is necessary, loosen locknut (B)

Fig. 26, and turn screw (C) until head of screw (C) con-

tacts casting (D) when blade is 90 degrees to the

table.Then tighten locknut (B).

5. Loosen bevel lock handle and move the cutting arm

all the way to the left bevel position and tighten bevel

lock handle.

6. Using a combination square (A) Fig. 27, check to see

if the blade is at 45 degrees to the table, as shown.

7. If an adjustment is necessary, loosen locknut (E)

Fig. 28, and turn screw (F) until screw (F) contacts cast-

ing (G) when blade is 45 degrees to the table. Then tight-

en locknut (E).

8. These positive stops enable you to rapidly position

the blade at the 90 and 45 degree bevel angle to the

table.

ADJUSTING 90 AND 45

DEGREE BEVEL STOPS

1. DISCONNECT THE SAW FROM THE POWER

SOURCE.

2. Loosen bevel lock handle and move the cutting arm

all the way to the right, then tighten the bevel lock

handle.

3. Using a square (A) Fig. 25, place one end of the

square on the table and the other end against the blade.

Check to see if the blade is at 90 degrees to the table, as

shown in Fig. 25.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Delta Sidekick 36-210 Instruction Manual Page 13