Delta Sidekick 36-210 Instruction Manual download pdf (Page 20)

Fig. 48

Fig. 49

Fig. 50

Fig. 51

BRUSH INSPECTION

AND REPLACEMENT

CAUTION: BEFORE INSPECTING BRUSHES, DISCON-

NECT THE MACHINE FROM THE POWER SOURCE.

Brush life varies. It depends on the load on the motor.

Check the brushes after the first 50 hours of use for a

new machine or after a new set of brushes has been

installed.

After the first check, examine them after about 10 hours

of use until such time that replacement is necessary.

The brush holders (A) Fig. 50, are located on the motor

housing opposite each other. Fig. 51, illustrates one of

the brushes removed for inspection. When the carbon on

either brush is worn to 3/16" in length or if either spring

or shunt wire is burned or damaged in any way, replace

both brushes. If the brushes are found serviceable after

removing, reinstall them in the same position as

removed.

3. Rotate arbor cover (B) Fig. 48, and lower guard (G) to

the rear, exposing arbor screw (C), as shown.

4. Remove arbor screw (C) Fig. 48, by turning screw

clockwise with wrench supplied while at the same time

pressing in on arbor lock (D) Fig. 49, to keep the arbor

from turning. Remove outside blade flange (E) Fig. 48,

and saw blade (F). DO NOT REMOVE INSIDE BLADE

FLANGE.

5. Assemble new saw blade MAKING CERTAIN TEETH

OF SAW BLADE ARE POINTING DOWN AT THE FRONT,

AS SHOWN and assemble outside blade flange (E)

Fig. 48, making sure flats on outside blade flange are

engaged with flats on arbor shaft.

6. Thread arbor screw (C) Fig. 48, into saw arbor by

turning screw (C) counterclockwise as far as possible by

hand. Then tighten arbor screw (C) with wrench supplied

while at the same time pressing in on arbor lock (D) Fig.

49, to keep arbor from turning.

7. Rotate arbor cover (B) Fig. 48, and lower guard (G) to

the front and replace screw that was removed in STEP 2.

1 2 ... 15 16 17 18 19 20

No comments

Delta Sidekick 36-210 Instruction Manual Page 20