Delta 36-714 User Manual download pdf (Page 15)

6. If alignment is necessary, loosen the two screws

(F) Fig. 18, align bracket (D) with the inner arbor

flange (E), and tighten screws (F).

7. Loosely assemble large washer and screw (C) Fig. 18,

to the inside splitter bracket. This screw and washer

was removed in STEP 3.

8. Assemble the blade guard and splitter assembly (G)

Fig. 19 between the large washer (C) and the splitter

bracket and tighten hex head screw (H) with 12mm

wrench.

9. Fasten the rear of the blade guard and splitter bracket

assembly (G) Fig. 20, to the rear splitter mounting

bracket using 5/16-18 x 5/8″ carriage bolt (J), 5/16”

flat washer and 5/16-18 hex nut. Align the hole

in the rear of the blade guard with the hole in the

splitter bracket. Insert the 5/16-18x5/8″ carriage

bolt through the holes. Place flat washer onto the

bolt, then place nut on bolt and tighten.

IMPORTANT: The splitter (G) Fig. 20, has a notch (L)

cut in the top edge. This feature will enable the

blade guard to stay in the raised position when the

table insert is removed to make blade changing

easier. Raise the front of blade guard (M) Fig. 21,

until the rear edge of the blade guard slips into

notch (L) of splitter (G); the blade guard will stay in

this position.

Always return guard down to table

before operating saw. Do not operate saw without

the table insert and guard in place.

Fig. 18

Fig. 19

Fig. 20

Fig. 21

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

No comments

Delta 36-714 User Manual Page 15