Delta 36-714 User Manual download pdf (Page 17)

Fig. 26

INSTALLING TABLE INSERT

Disconnect machine from power source.

Lower saw blade and install table insert (P) Fig. 26, in

the saw table. IMPORTANT: When installing the table

insert, make certain to hold on to the blade guard (L).

The insert will automatically release the holding action on

the splitter and lower the blade guard when the insert is

installed in the table opening.

Insert M5x20mm screw into hole (M) Fig. 26 and

tighten.

INSTALLING TOOL HOLDERS

Disconnect machine from power source.

Install fence holders (A) Fig. 27 using four self-tapping

screws (4).

Install wrench hook (B) using two self-tapping screws.

Install miter gage holder (C) Fig. 28 underneath the motor

cover on the right side of the saw using four self-tapping

screws.

Fig. 27

Fig. 28

Fig. 29

INSTALLING DUST PORT

Disconnect machine from power source.

Attach dust port (D) Fig. 29 using four self-tapping

screws.

ADJUSTING TABLE INSERT

Disconnect machine from power source.

Place a straight edge (B) Fig. 26A across the table at both

ends of the table insert (A) as shown in Fig. 26A.

THE TABLE INSERT (A) SHOULD

ALWAYS BE LEVEL WITH THE TABLE.

If an adjustment is necessary, loosen screw (M) Fig. 26

and turn the adjusting screws (C) Fig. 26A, as needed,

with allen wrench supplied.

Fig. 26A

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

No comments

Delta 36-714 User Manual Page 17