Delta 36-714 User Manual download pdf (Page 18)

ASSEMBLING MITER GAGE

Disconnect machine from power source.

Place a flat washer (A) Fig 30 on the threads of the miter

gage lock handle (B) and then thread the handle into the

hole (C) in miter gage bar.

Insert plate (D) Fig.41 into the miter gage slot (E) Fig. 41

and slide miter gage onto saw table.

Fig. 30

OPERATION

STARTING AND STOPPING SAW

The on/off switch is located underneath the switch

shield (A) Fig. 32. To turn the saw “ON”, press the green

button (B) Fig. 31 below the shield. To turn the saw

“OFF”, push switch shield (A) Fig. 32.

Make sure that the switch is in the “OFF”

position before plugging in the power

cord. In the event of a power failure, move the switch

to the “OFF” position. An accidental start-up can cause

injury.

LOCKING SWITCH IN “OFF” POSITION

IMPORTANT: When the tool is not in use, the switch

should be locked in the “OFF” position to prevent

unauthorized use. Use a padlock (C) Fig. 31 with a

3/16" diameter shackle.

OPERATIONAL CONTROLS AND ADJUSTMENTS

Fig. 31

Fig. 32

OVERLOAD PROTECTION

The saw is equipped with a circuit breaker (A) Fig. 31.

If the motor shuts off or fails to start due to overloading

(cutting stock too fast, using a dull blade, using the saw

beyond its capacity, etc.), or low voltage, turn the saw

off by pushing the switch shield (D) Fig. 32. Let the motor

cool three to five minutes and push the reset button (A)

Fig. 31, which will reset the overload device. The motor

can then be turned on again in the usual manner.

NOTE: If the problem persists, contact the nearest

Delta customer service center or call (800) 438-

2486.

In the event of a power outage (such

as a breaker or fuse trip), always move the switch to

the “OFF” position until the main power is restored.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

No comments

Delta 36-714 User Manual Page 18