Delta 14-650 Instruction Manual download pdf (Page 11)

Fig. 23

6. The flat portion of the bit should be adjusted to a

minimum of 1/16" away from the bottom of the chisel, as

shown in Fig. 25. For certain types of wood it may be

necessary to increase this distance up to a maximum of

3/16" clearance. This method assures having proper

clearance between the cutting lips of the bit and the points

of the chisel.

Fig. 24

Fig. 25

5. Loosen set screw (D) Fig. 24, and push chisel (B) up

against bottom of bushing (E), as shown, and tighten set

screw (D). This should provide the proper distance be-

tween the cutting lips of the bit and the points of the

chisel.

4. Push bit (A) Fig. 23, up through chisel and into

chuck (G) as far as it will go, and then back the bit off

1/16", and lock bit in chuck using chuck key supplied.

PUSH

CHISEL UP

AGAINST

BUSHING

ADJUST BIT IN

CHUCK TO GIVE

CLEARANCE

" to

CLEARANCE TO SUIT

TYPE OF WOOD

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Delta 14-650 Instruction Manual Page 11