Delta 14-650 Instruction Manual download pdf (Page 8)

Fig. 13

Fig. 14

Fig. 15

7. Assemble the holddown (H) Fig. 13, onto bar (F) as

shown, and tighten set screw (J) against flat on bar.

ASSEMBLING TOOL

AND CHISEL HOLDER

1. Assemble tool and chisel holder (A) Fig. 14, to side

of column using the two M6 x 25mm screws (B) and flat

washers as shown.

2. Fig. 15, illustrates the chuck key (C), wrench (D) and

chisels and bits (E) in holes of tool and chisel holder (A)

when not in use.

FASTENING MORTISER TO SUPPORTING SURFACE

Fig. 16

This machine must be fastened to a supporting surface

to prevent it from tipping during operation. Two holes are

supplied in the base casting to accept screws (A) Fig.

16, for this purpose.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

No comments

Delta 14-650 Instruction Manual Page 8