Delta 23-725 Instruction Manual download pdf (Page 8)

8 - English

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is

completely assembled and you read and understand the entire instruction manual.

ASSEMBLY TOOLS REQUIRED

* 13 mm/16 mm Wrench (supplied)

* 10 mm socket or open end wrenches (not supplied)

* Phillips head screwdriver (not supplied)

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes approximately 1 hour.

TOOL RESTS

Disconnect machine from power source!

1. The tool rest arms (F) Fig. 2, are universal and can

be attached to either side of the grinder. Assemble

adjustable tool rest (J) Fig. 2, to left side of tool rest

arm (F) Fig. 2, as shown, and fasten with one bolt

(K) Fig. 1, and one washer (P) Fig. 1, as shown.

Assemble the remaining tool rest to the right side of

the other tool rest arm in the same manner. Do not

completely tighten hardware at this time.

2. To identify the left & right tool rests place them, as

they would be assembled on the tool Fig. 3. The left

tool rest will have a threaded hole on the right side

of the tool rest, and the right tool rest will have a

threaded hole on the left side of the tool rest.

3. Attach left tool rest assembly Fig. 3, to the inside of

left wheel guard, and fasten with two bolts (L) Fig. 1,

and two washers (Q) Fig. 1 as shown in Fig. 3.

4. Attach right tool rest assembly to the inside of right

wheel guard and fasten with two bolts (L) Fig. 1 and

two washers (Q) Fig. 1 in the same manner.

5. Each tool rest is adjustable so that the edge of the

tool rest can be positioned as close to the grinding

wheel as possible giving maximum support to

the piece that is being ground. A distance of 1/8"

(3.2 mm) or less between the grinding wheel and the

edge of the tool rest should always be maintained. As

the grinding wheel wears down to a smaller diameter,

re-adjust the tool rest closer to the wheel. The tool

rest should be adjusted so it is set a little below the

center of the wheel. This is the most practical and

safest position for general work. Free-hand grinding

without the use of the tool rest should always be

done on the lower quarter of the wheel.

Fig. 2

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments

Delta 23-725 Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Delta 23-725