Delta 23-725 Instruction Manual download pdf (Page 9)

9 - English

EYE SHIELDS

Disconnect machine from power source!

Always wear eye protection.

1. Assemble long end of eye shield mounting rod (D)

Fig. 1, to the side of each wheel guard using the eye

shield rod bracket (E) Fig. 1, and screw (N) Fig. 1,

and washer (R) Fig. 1. Note: The mounting rod

should be positioned so that the "L" shaped end of

the mounting rod is pointing outward, away from the

machine. Fig. 5

2. Insert the "L" shaped end of mounting rod (D) Fig. 5,

into hole of frame (C) Fig. 5. Nut (A) may need to be

loosened before inserting mounting rod. The eye

shield (C) is fully adjustable so it can be put in any

position by moving the shield (C) and repositioning

rod (D). Tighten nut (A) securely after shield is

positioned.

3. Assemble the remaining eye shield to other wheel

guard in the same manner.

WATER TRAY

Disconnect machine from power source!

To assemble the water tray (B) Fig. 6 , align holes in the

water tray, with the holes in the front of the grinder, insert

two screws (O) Fig. 1, and tighten securely.

SPARK GUARDS

Disconnect machine from power source!

The spark guard (I) Fig. 4, is to be mounted to the side

of each wheel guard, using one bolt (M) Fig. 1, and one

washer (R) Fig. 1 as shown in Fig. 4. The spark guard (I)

should be adjusted as close as possible to the grinding

wheel so that sparks never strike the operator’s hand.

As the wheels wear down, the spark guard (I) should be

adjusted accordingly.

Fig. 4

R M

Fig. 6

Fig. 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Delta 23-725 Instruction Manual Page 9