Delta 28-299A Instruction Manual download pdf (Page 6)

ATTACHING MOTOR PULLEY

Attach the motor pulley (A) Fig. 7 to the motor shaft, making

sure that the set screw (B) in the motor pulley engages with

the key (C) in the motor shaft. NOTE: The key (D) Fig. 5 is

shipped taped to the motor. Remove it, place it on the motor

shaft, and attach the pulley over it.

Fig. 7

ASSEMBLY

STAND

The stand is shipped top-down in the shipping container

with the motor mounted to the inside top of the stand. The

on/off switch is wired to the end of the power cord.

To make the motor operational, do the following:

1. Remove the stand (A) Fig. 4 from the shipping container.

NOTE: Set the stand on several blocks of wood to raise the

stand off the floor.

2. Take the panel (B) Fig. 4 off of the stand (A) by removing

two screws (C) and loosening the two other screws (D).

Remove the panel on the opposite side of the stand in the

same way.

Fig. 4

Fig. 5

3. Remove the two mounting screws that are holding the

motor (F) Fig. 5 to the top of the stand. One screw is shown

at (E) Fig. 5.

4. Remove motor from stand.

Fig. 6

ATTACHING MOTOR TO STAND

1. Turn the stand on its side with the two bars (B) Fig. 6

down.

2. Position the motor (C) Fig. 6 on the two horizontal sup-

port bars (B), and fasten with the four 5/16x18 carriage bolts

and flange nuts, three of which are shown at (F). IMPOR-

TANT: PLACE THE MOTOR SHAFT (E) ON THE SAME

SIDE OF THE STAND AS THE LARGE OPENING AT THE

TOP OF THE STAND (SEE (B) FIG. 8) BEFORE LOOSELY

TIGHTENING THE CARRIAGE BOLTS (F). Further align-

ment will be necessary after the saw is attached to the

stand.

3. Carefully turn the stand right side up.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Delta 28-299A Instruction Manual Page 6