Delta 28-299A Instruction Manual download pdf (Page 8)

Fig. 17

Fig. 18

STARTING AND STOPPING SAW

To start the tool, press the “START” button (K) Fig. 17. To stop the tool, press the “STOP” button (L) Fig. 17.

LOCKING SWITCH IN THE OFF POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unau-

thorized use, using a padlock (M) Fig. 18 with a 3/16" diameter shackle.

Fig. 15

Fig. 16

5. Use the two nuts and lockwashers (E) Fig. 14, removed in

STEP 3, to fasten the switch box to the bandsaw arm (Fig. 14).

6. Remove the screw (F) and cable clamp (E) Fig. 15 from the

lower arm of the band saw.

7. Insert the switch cord and power cord (F) Fig. 16 into the

clamp (E) (removed in STEP 6), and fasten to the bandsaw.

8. Push connector end of switch cord through the plastic

bushing (G) Fig 16A. and plug it into the motor cord.

IMPORTANT: Be certain to prevent contact between the

switch-to-motor cord (F) Fig. 16 and the motor pulley or belt.

If necessary, adjust the cord, then tighten the cable tie (H)

Fig.11.

9. Attach the two side panels removed earlier.

Fig. 14

Fig. 19

TABLE INSERT

Place the table insert (A) Fig. 19 in the hole provided in the

table. Engage the protrusion on the insert in the indent (B) in

the table.

Fig. 16A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 28-299A Instruction Manual Page 8