Delta 36-714B Instruction Manual download pdf (Page 10)

Fig. 11 Fig. 12

Fig. 13

Fig. 14

Fig. 15

ASSEMBLING ON/OFF

SWITCH

1. Loosely assemble switch and switch bracket (A) Fig.

12, to the inside front lip of the left extension wing with

5/16-18x1" hex flat head screw (D), 5/16" flat washer (E),

and 5/16-18 hex nut (F) through hole (G) Fig. 11.

2. Attach the side of switch bracket (A) Fig. 12, to the

inside of extension wing at the front of the saw using the

7/16"-20x1

/4" screw and 7/16" lockwasher.

3. Tighten screws (C) and (D), Fig. 12, securely.

ASSEMBLING BLADE

GUARD AND SPLITTER

ASSEMBLY

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Remove the table insert and saw blade from the

machine by following instructions under section

“REMOVING SAW BLADE.”

3. The inside splitter mounting bracket (A) Fig. 13, is

assembled to the inside of the saw and aligned at the

factory. To check the alignment of the bracket (A) to the

inside arbor flange, remove screw and splitter fastener

plate (B) Fig. 13.

4. Using a straight edge (C) Fig. 14, check to see if the

splitter bracket (A) is aligned with the inside blade flange

(D). Check both the top and bottom of bracket (A) with

top and bottom of flange (D).

5. If an adjustment is necessary, loosen two screws (F)

Fig. 15, and adjust splitter bracket (A) until it is aligned

with the blade flange; tighten two screws (F). Loosely

reassemble screw and plate removed in STEP 3.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 10