Delta 36-714B Instruction Manual download pdf (Page 13)

MOTOR COVER

Removing the motor cover

To remove the motor cover, push motor cover to one side

to depress clips, and rotate motor cover away from the

cabinet.

Attaching the motor cover

Place the motor cover (A) in the opening of the Unisaw as

shown in Fig. 31. Place the rear motor cover clips inside

the motor opening and push the front of the motor cover

until all 4 motor cover clips are engaged with the motor

cover opening in the Unisaw.

Fig. 32 shows the motor cover attached to the Unisaw.

Fig. 31

Fig. 32

Fig. 33

Fig. 34

ASSEMBLING RIP FENCE

HOLDER BRACKETS

Assemble the rip fence holder brackets (A) and (B) Fig.

33, to the four holes located in the right hand side of the

saw cabinet using four #10 x 1/2" sheet metal screws

supplied. Figure 34 illustrates the Biesemeyer fence (C),

(when not in use), positioned on the two holder brackets.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 13