Delta 36-714B Instruction Manual download pdf (Page 37)

MAINTENANCE

CHANGING THE SAW BLADE

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. NOTE: Two wrenches are supplied with the saw for

changing the saw blade; a box end wrench and open end

wrench.

3. Remove table insert and raise saw blade to its

maximum height.

4. Place the open end wrench (B) Fig. 130, on the flats

of the saw arbor to keep the arbor from turning, and using

wrench (A), turn the arbor nut (C) clockwise. Remove

arbor nut, blade flange and saw blade.

5. Assemble the new blade, making certain the teeth are

pointing down at the front of the saw table and assemble

outside blade flange and arbor nut. With wrench (B) Fig.

130, on the flats of the arbor to keep it from turning,

tighten arbor nut by turning wrench (A) counterclockwise.

6. Replace table insert.

Fig. 130

REPLACING BELTS AND

ADJUSTING BELT TENSION

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Remove motor cover door to gain access to the

motor.

3. Place a block of wood (C) Fig. 131, between the

motor and saw cabinet as shown. NOTE: It may be

necessary to raise the saw arbor in order to insert the

wooden block. Lower the saw arbor until the motor

contacts the wood.

4. Loosen bolt (D) Fig. 131, and continue to lower the

saw arbor until all tension is removed from the belts (E).

Tighten bolt (D).

5. Raise the saw arbor slightly and remove the block of

wood (C) Fig. 131.

6. Lower the saw arbor.

7. Remove the belts (E) Fig. 132, one at a time from the

arbor pulley (F).

8. Assemble the three new belts, one at a time in the

grooves of the arbor pulley (F) Fig. 132, and onto the

motor pulley.

9. When the new belts are assembled on the arbor

pulley (F) Fig. 132 and the motor pulley, loosen screw (D)

Fig. 132, and carefully let the motor rest on the belts.

10. Correct belt tension is when there is approximately

1/4" deflection in the center span of the pulleys, using

light finger pressure. After tension is applied, tighten

screw (D) Fig. 131.

Fig. 131

Fig. 132

NOTE: Use only 10" saw blades with

5/8" arbor holes, rated for at least

4000 RPM.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

Comments to this Manuals

No comments

Delta 36-714B Instruction Manual Page 37

Comments to this Manuals

Related products and manuals for Power tools Delta 36-714B