Delta 36-714B Instruction Manual download pdf (Page 27)

ASSEMBLY INSTRUCTIONS FOR MODELS 36-844 &

36-845 50" COMMERCIAL BIESEMEYER FENCE

ASSEMBLING GUIDE RAILS

1. Assemble the front rail (A) Fig. 92, to front of saw

table using the two 3/8-16 x 1-1/4" long flat head Phillips

screws (B), 7/8" flat washers, lockwashers and 3/8-16

hex nuts supplied. Screws (B) are inserted through the

two holes in the front rail, as shown and through the two

through holes in the front of the saw table and fastened

to the table with the flat washers, lockwashers and hex

nuts. IMPORTANT: Do not completely tighten front rail

mounting hardware at this time.

2. Using template (D) Figures 93 and 94, to check and

adjust front rail at both ends of the saw table as shown,

to make sure rail (A) is parallel with table surface and

tighten rail mounting hardware (B). IMPORTANT:

Template (D) must be on the saw table when check-

ing, not on extension wing.

3. Assemble rear rail (E) Fig. 95, to rear of saw table by

placing a lockwasher onto a 3/8-24 x 1-1/4" long hex

head screw (F), then place a 7/8" O.D. flat washer onto

the hex head screw, and insert the screw through the rail

and thread the screw into the tapped hole in the saw.

4. Make certain top edge of rail (E) Fig. 95 is below table

surface and that top edge of cut-outs (G) are below miter

gage slots before tightening screws (F).

Fig. 92

Fig. 93

Fig. 94

Fig. 95

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 27