Delta JT160 Instruction Manual download pdf (Page 15)

6. If the knives are set too low, the result will be as

shown in Fig. 32, and the finished surface will be

curved.

7. If the knives are set too high, the work will be

gouged at the end of the cut, as shown in Fig. 33.

8. As a final check, run a piece of work slowly over the

knives for 6 to 8 inches. The wood should rest firmly

on both tables as shown in Fig. 34, with no open

spaces under the finished cut.

Fig. 32

Fig. 33

Fig. 34

KNIVES

SET TOO LOW

OUT-FEED

TABLE

IN-FEED TABLE

CUTTER

MATERIAL

KNIVES

SET TOO HIGH

IN-FEED TABLE

OUT-FEED

TABLE

CUTTER

GOUGE

MATERIAL

IN-FEED TABLE

CUTTER

OUT-FEED

TABLE

KNIVES AT

CORRECT HEIGHT

MATERIAL

CHIP AND DUST CHUTE

A chip and dust chute (A) Fig. 35 is provided on the outfeed end of the jointer base for efficient chip removal.

KEEP HANDS OUT OF CHIP AND DUST CHUTE AT ALL TIMES.

PUSH BLOCKS

A set of push blocks (A) Fig. 36 is supplied with your jointer and should be used whenever possible to minimize all

danger to your hands. Fig. 36 illustrates using the push blocks properly.

Fig. 35

Fig. 36

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Delta JT160 Instruction Manual Page 15