Delta JT160 Instruction Manual download pdf (Page 18)

Fig. 44

Fig. 45

BELT REPLACEMENT

When it becomes necessary to replace the belt on your

jointer:

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Remove screw (A) Fig. 44, using hex wrench

supplied, and remove belt guard (B).

2. Loosen three screws (C) Fig. 45, to release belt

tension and remove belt (D) from pulleys.

3. Assemble new belt to the cutterhead and motor

pulleys. Press down on motor pulley (E) Fig. 45, to

tension belt and tighten three screws (C).

NOTE: THERE SHOULD BE APPROXIMATELY 1/4

INCH DEFLECTION IN THE BELT (D) AT THE

CENTER SPAN OF THE PULLEYS USING LIGHT

FINGER PRESSURE. THE BELT DOES NOT

REQUIRE EXCESSIVE TENSION TO FUNCTION

PROPERLY.

4. Replace belt guard (B) Fig. 44.

MAINTENANCE

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth.

NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.

Wear ANSI Z87.1 safety glasses while using compressed air.

FAILURE TO START

Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet. Also,

check for blown fuses or open circuit breakers in the line.

LUBRICATION

Apply household floor paste wax to the machine table and extension table or other work surface weekly.

PROTECTING CAST IRON FROM RUST

To clean and protect cast iron tables from rust, you will need the following materials: 1 pushblock from a jointer, 1 sheet

of medium Scotch-Brite™ Blending Hand Pad, 1 can of WD-40

, 1 can of degreaser, 1 can of TopCote

Aerosol. Apply

the WD-40 and polish the table surface with the Scotch-Brite pad using the pushblock as a holddown. Degrease the

table, then apply the TopCote

accordingly.

1 2 ... 13 14 15 16 17 18 19 20 21

No comments

Delta JT160 Instruction Manual Page 18