Delta N028314 Instruction Manual download pdf (Page 11)

1. Lift the motor to remove the foam packing block.

2. While lifting the motor (A) Fig. 5, place a 10" - 12"

(254 mm to 305 mm) long piece of 2x4 (B) under the

motor bracket to prop up the motor.

3. Place one end of the grooved belt (C) Fig. 6 onto the

grooved pulley located behind the motor (shown in

Fig. 7). Place the other end of the grooved belt onto

the grooved pulley located directly above on the blade

arbor.

Ensure that the grooves of the belt completely make contact

with the grooves in these pulleys.

4. Carefully lift the motor and remove the block of wood.

The weight of the motor will provide the correct tension

on the belt.

5. The belt (C) Fig. 8 is shown installed correctly as seen

through the open door in the side of the saw.

INSTALLING THE DRIVE BELT

Disconnect the machine from the power source!

Fig. 5

Fig. 6

Fig. 7

Fig. 8

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 87 88

No comments

Delta N028314 Instruction Manual Page 11