Delta N028314 Instruction Manual download pdf (Page 16)

1. Install the fence holders (A) Fig. 31 using four 1/4-20 x

3/8" (9.5 mm) round head tap screws.

2. Install the wrench hook (B) using two M4 x 8 mm self-

tapping screws.

Attach the dust port (D) Fig. 33 using four 1/4-20 x 3/8"

(9.5 mm) self-tapping screws.

Make sure that the throat plate (A) is always

level with the table.

Place a straight edge (B) Fig. 30 across the table at both

ends of the throat plate (A).

To adjust, loosen the screw (D) Fig. 30 and turn the adjusting

screws (C) Fig. 30 with the supplied hex wrench.

ADJUSTING THROAT PLATE

Fig. 30

Fig. 31

Fig. 33

INSTALLING THE TOOL HOLDERS

INSTALLING DUST PORT

Place a flat washer (A) Fig 34 on the threads of the miter

gauge lock handle (B). Thread the handle into the hole (C)

in the miter gauge bar.

Insert the plate (D) (Inset) into the miter gauge slot (E). Slide

the miter gauge on the saw table.

ASSEMBLING THE MITER GAUGE

Fig. 34

Disconnect the machine from the power

source!

Disconnect the machine from the power

source!

Disconnect the machine from the power

source!

Disconnect the machine from the power

source!

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

No comments

Delta N028314 Instruction Manual Page 16