Delta 50-762 Instruction Manual download pdf (Page 8)

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

CASTERS

1. Turn stand (A) upside down, as shown in Fig 1F.

2. Align holes in caster assembly (B) with holes in

plates on stand. Place small 5/16” flatwasher on a

5/16”x3/4” hex head screw and insert screw into

hole in caster assembly and thread into the hole

in the stand. Repeat for all holes in all casters.

3. Tighten hardware by hand, then set with a 12mm

wrench.

Fig. 1F

ATTACHING STAND TO LEGS ON

MOTOR/BLOWER ASSEMBLY

NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.

Place all four stand posts (A) Fig. 3 into four legs (B) on

motor/blower assembly. Make sure metal base plates

(D) are arranged over the large holes in the dust

collector (C).

Fig. 3

LEGS TO MOTOR/BLOWER

ASSEMBLY

1. Place motor/blower assembly with the motor (A)

Fig. 2 down.

2. Place 3/8” (18 mm) flatwasher on knob (B).

3. Align holes on legs (C) with holes (D) in the

motor/blower assembly. Legs should extend up.

Insert knob through hole in the legs (C) and into

threaded hole in the motor/blower assembly (D).

Tighten knob securely.

4. Repeat steps for all knobs on both legs.

Fig. 2

THIS MACHINE IS HEAVY. USE TWO

OR MORE PEOPLE WHEN LIFTING.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 50-762 Instruction Manual Page 8