Delta 14-65l User Manual download pdf (Page 7)

7 - English

ATTACHING THE TOOL AND CHISEL HOLDER

1. Attach the tool and chisel holder (A) Fig. 5 to the back of the column, using the two M6x1x25mm screws (B) and

M6 lockwashers.

2. Fig. 6 illustrates the stored chuck key/wrench (C), bushing (F) for use with extra long chisels, and chisels and bits (E).

RAISING AND LOWERING THE HANDLE

1. Attach the hub of the handle assembly (A) Fig. 1 to the end of the pinion shaft (B). Fasten the handle to the pinion

shaft using the special screw (C) and spring (D).

2. Raise the mortising machine head (E) Fig. 2 to the "up" position by turning the handle (A) clockwise.

NOTE: The handle (A) is spring-loaded. Reposition it by pulling it out and moving it on pinion shaft (B).

ATTACHING THE HYDRAULIC CYLINDER

Place the head (A) Fig. 3 in the “up” position. Attach the hydraulic cylinder (B) to the two fittings, one located on the

back of the head (C) Fig. 3, and the other on the column (D) Fig. 4. Push each end of the hydraulic cylinder on its fitting

to secure the cylinder.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is

completely assembled and you read and understand the entire instruction manual.

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes less than 30 minutes.

Chuck Key/Wrench (Supplied)

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Delta 14-65l User Manual Page 7