Delta 34-814 Instruction Manual download pdf (Page 12)

8. Use a 5/16-18x1" hex head bolt (N) with 5/16"

lockwasher and 5/16" flat washer to attach the upper

splitter bracket (M) Fig. 20 to the lower bracket (L) .

NOTE: Hand tighten only.

9. Insert the front end of splitter (P) Fig. 21, inside the

splitter mounting bracket, behind the splitter fastener

plate and the screw (C). Push the splitter down as far

as possible, making certain that the bottom edge of

splitter (P) is parallel with the table surface. Tighten

the screw (C). Fasten splitter and blade guard

assembly (P) Fig. 22 to the bracket (M) using a 5/16-

18x1" hex head bolt (V) and 5/16" flat washer.

IMPORTANT: The splitter (P) Fig. 23, features a notch (W)

cut into the top edge. Raise the front of the clear blade

guard (P) Fig. 23, until the rear edge of the guard slips into

notch (W) of the splitter. This notch enables the blade

guard to stay in the raised position and makes changing

blades easier.

11. Install the saw blade, making certain the teeth are

pointing down at the front of the saw table (Fig. 24).

Install the outside blade flange and arbor nut (X). With

open-end wrench (Y) on the flats of the arbor to keep

it from turning, tighten arbor nut by turning box-end

wrench (Z) counter-clockwise.

Fig. 20

Fig. 21

Fig. 22

Fig. 23

Fig. 25

Fig. 24

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Delta 34-814 Instruction Manual Page 12