Delta 34-814 Instruction Manual download pdf (Page 13)

12. Use a straight edge (A) Fig. 25 to make certain that

the splitter (P) is aligned with the saw blade (B). Use

a square (C) Figs. 27 and 28 to make certain that the

saw blade (B) Fig. 26 and splitter (P) Fig. 27 are 90°

to the table surface. Tighten all splitter mounting

hardware (D) Fig. 27 and re-check the alignment.

13. Hold the clear blade guard (X) Fig. and lower the saw

blade. Attach the table insert (E) Fig. 30 into the

opening on the saw table.

Fig. 26

Fig. 27

Fig. 28

1. Raise the saw arbor by turning the height adjusting

handle on the front of the saw counter-clockwise as

far as it will go. Then turn the angle adjusting handle

on the front of the saw clockwise as far as it will go.

2. Fasten motor cord (A) Fig. 29 to the saw frame cross

member (B), using the cable tie (C) supplied with the

saw.

CAUTION: Before tightening the cable tie, make certain

that the electrical cord (A) is free of any interference from

the motor or saw blade in all positions.

3. After the cable tie is tightened, cut off the excess tail

FASTENING THE MOTOR CORD TO THE SAW FRAME

Fig. 29

ATTACHING MOTOR COVER

NOTE: If you have an “LVC” (Starter Box) version

Unisaw, you will have to attach two bottom spring

clips to the motor cover. The spring clips come

attached to the “GPE version Unisaw.

1. Attach the two motor cover clips to the motor cover.

Align the hole in the motor cover clip with the hole

in the motor cover. Place a 13/64 flat washer on a

10-32 x 1/2" screw (A) Fig. 30. Insert the screw

through the hole in the motor cover clip and thread

the screw (A) into the tapped hole in the motor cover.

Fig. 30

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

No comments

Delta 34-814 Instruction Manual Page 13