Delta 34-814 Instruction Manual download pdf (Page 20)

When ripping material with a veneer facing that extends

over the material, the fence (A) should be in the horizontal

position with the veneer (B) extending over the lip of the

fence, as shown in Fig. 53

When ripping material with a veneer facing and the

material is not thick enough for the veneer to extend over

the lip of the fence or if the veneer facing (B) is on both

sides of the material, as shown in Fig. 54, the fence can be

positioned slightly above the surface of the table. The

veneer can be placed between the fence and the table or

the veneer can straddle the fence with the material solidly

against the fence.

In some cases it may be desirable to use the fence on the left side of the saw blade. This is easily accomplished by

repositioning the fence (A) Figs. 55 and 56, fence clamp bar (B), and lock knobs (C) so that the fence (A) will be attached to

the right side of the fence body, as shown in Fig. 56. The complete fence assembly (D) Fig. 56, can easily be moved to the

left side of the saw table.

RIPPING ON LEFT SIDE OF SAW BLADE

Fig. 53

Fig. 54

Fig. 55

Fig. 56

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:44 PM Page 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Delta 34-814 Instruction Manual Page 20