Delta 31-392 User Manual download pdf (Page 13)

EDGE SANDING

When edge sanding, it is advisable to raise one end of

the table as shown in Fig. 36. This allows cooler belt

running, prevents spot wear, reduces material burning

and promotes longer belt life. The table should be

positioned so it is close to, but not contacting the

sanding belt.

CONTOUR SANDING AROUND THE

DRIVE PULLEY

IMPORTANT: The hinged dust chute (A) Fig. 37, must be

flipped up to allow contour sanding around the drive

pulley (C). The auxiliary end table (B) should be used to

support the workpiece. The table (B) should be

positioned close to, but not touching the sanding belt

(C). It is advisable to raise or lower the table (B)

periodically to prevent spot wear and improve belt life.

CONTOUR SANDING AROUND THE

AUXILIARY ABRASIVE DRUM

SPINDLE

IMPORTANT: The hinged dust chute (A) Fig. 38, must be

flipped up to allow contour sanding around the auxiliary

abrasive drum (B). Whenever possible the auxiliary end

table (C) should be used to support the workpiece when

contour sanding. The auxiliary end table (C) should be

positioned close to but not touching the abrasive drum

(B). It is advisable to raise or lower the table (C)

periodically prevent spot wear and improve drum life.

OPERATIONS

Fig. 36

Fig. 37

Fig. 38

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Delta 31-392 User Manual Page 13