Delta 31-552 User Manual

Browse online or download User Manual for Grinding machines Delta 31-552. Delta 31-552 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated4.8 / 5. Based on18 customer reviews
Page view 0
INSTRUCTION MANUAL
6" Abrasive Belt
Finishing Machine
(Model 31-552)
PART NO. 406-03-651-0017 (0110)
Copyright © 2001 Delta Machinery
To learn more about DELTA MACHINERY
visit our website at: www.deltamachinery.com.
For Parts, Service, Warranty or other Assistance,
please call
1-800-223-7278 (In Canada call 1-800-463-3582).
6" Abrasive Belt Finishing Machine
shown with optional enclosed steel
stand and electricals.
Page view 0
1 2 3 4 5 6 ... 11 12

Summary of Contents

Page 1 - Finishing Machine

INSTRUCTION MANUAL6" Abrasive BeltFinishing Machine(Model 31-552)PART NO. 406-03-651-0017 (0110)Copyright © 2001 Delta MachineryTo learn more abo

Page 2 - GENERAL SAFETY RULES

10INSTALLING OR REMOVINGABRASIVE BELTYour machine uses a 6"x48" belt. To install or remove thebelt, proceed as follows:DISCONNECT MACHINE FR

Page 3 - Refer to them often

11ABRASIVE BELTS - THEIR SELECTION AND USEDelta supplies a wide range of belts for use on your Finishing Machine. These belts are recommended for a wi

Page 4

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): BAMMER®,INNOVATION THAT WORKS®, JETST

Page 5 - OPERATING INSTRUCTIONS

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

Page 6 - ASSEMBLY

ADDITIONAL SAFETY RULES FORABRASIVE BELT FINISHING MACHINES3WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURYSAVE THESE INS

Page 7 - ASSEMBLING BELT GUARD

4POWER CONNECTIONSIMPORTANT: Make sure the electrical characteristics are the same between the motor nameplate and the powersource and make sure the

Page 8

5Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug

Page 9 - SANDING ARM

6ASSEMBLYSTAND AND ELECTRICALSIf you purchased your machine with the optional steelstand and electricals, the stand is shipped as shown inFig. 2. The

Page 10 - ADJUSTING THE PLATEN

7ALIGNING PULLEYS,ASSEMBLING BELT ANDADJUSTING BELT TENSIONDISCONNECT MACHINE FROM POWER SOURCEUsing a straight edge (A) Fig. 6, make certain the moto

Page 11 - ACCESSORIES

8OPERATING CONTROLS AND ADJUSTMENTSSTARTING AND STOPPINGTHE ABRASIVE FINISHINGMACHINETo start the machine, push “ON” button (A) Fig. 10. Tostop the ma

Page 12 - • DELTA)

9ADJUSTING TABLEDISCONNECT MACHINE FROM POWER SOURCE.To tilt the table, loosen the table tilting handle (A) Fig. 15,move the table to the desired angl

Comments to this Manuals

No comments