Delta 31-552 User Manual download pdf (Page 9)

ADJUSTING TABLE

DISCONNECT MACHINE FROM POWER SOURCE.

To tilt the table, loosen the table tilting handle (A) Fig. 15,

move the table to the desired angle, and tighten the table

tilting handle. The table tilting handle can be reposition-

ed by pulling out the handle and repositioning it on the

hex nut located underneath the handle. Positive table

stops are provided at 90° (A) Fig. 17, and 45° (B) Fig. 17.

To adjust the stops, proceed as follows:

1. Loosen the table locking handle (A) Fig. 15, and lift

the table up to approximately 10 degrees.

2. Flip out stop bracket (C) Fig. 16, and lower the table

until the adjustable screw (D) contacts stop bracket (C).

3. Place a square on the table with one end of the

square against the platen.

4. Turn the adjusting screw (D) Fig. 16 until the table is

at 90° to the platen and adjust the pointer (E) Fig. 15, to

the 0° mark on the angle-of-tilt scale (F) Fig. 15.

5. The same procedure is followed when adjusting the

table to stop at the 45° position as shown in Fig. 17.

Fig. 15

Fig. 16

Fig. 17

ADJUSTING POSITION OF

SANDING ARM

DISCONNECT MACHINE FROM POWER SOURCE.

The sanding arm can be positioned in the vertical or

horizontal position, or at any desired angle in between as

follows:

1. Loosen two bolts (A) Fig. 18, move the sanding arm

to the desired position, and tighten the two bolts.

CAUTION: THE SANDING ARM SHOULD NEVER BE

REPOSITIONED WHILE THE MACHINE IS RUNNING.

2. When moving the sanding arm to the horizontal posi-

tion, the arm will contact the stop (B) as shown in Fig. 19.

IMPORTANT: BEFORE STARTING THE MACHINE

AFTER REPOSITIONING THE SANDING ARM

ALWAYS CHECK THE TRACKING OF THE BELT.

Fig. 18

Fig. 19

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta 31-552 User Manual Page 9