Delta 36-075 Instruction Manual download pdf (Page 10)

Fig. 19 Fig. 20

REAR SUPPORT/CARRYING HANDLE

A rear support bar (A) Fig. 19, is provided to prevent the miter saw from tipping to the rear when the cut-

tinghead is returned to the up position after a cut has been made. For maximum support the bar (A) should

be pulled out as far as possible.

The support bar (A) also acts as a carrying handle, as shown in Fig. 20, when transporting the saw.

TILTING CUTTINGHEAD FOR BEVEL CUTTING

The cuttinghead of your compound miter saw can be tilted to cut any bevel angle from a 90 degree straight

cut off to a 45 degree left bevel angle by loosening bevel lock handle (A) Fig. 18, tilting cutting arm (B) to the

desired angle and tightening lock handle (A).

Positive stops are provided to rapidly position the saw blade at 90 and 45 degrees to the table. Refer to the

section of this manual titled “ADJUSTING 90 AND 45 DEGREE BEVEL STOPS.” The bevel angle of the

cutting arm is determined by the position of the pointer (C) Fig. 18, on the scale (D).

In addition, a triangle indicator is provided on the bevel scale at the 33-7/8 degree bevel angle for cutting

crown moulding. Refer to the “CUTTING CROWN MOULDING” section of this manual.

Fig. 18

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

No comments

Delta 36-075 Instruction Manual Page 10