Delta 36-322L Instruction Manual download pdf (Page 22)

BRUSH INSPECTION AND REPLACEMENT

Brush life varies, depending on the load on the motor. Check the brushes after the first 50 hours, or after a new set of brushes

has been installed.

After the first check, examine them about every 10 hours.

The brush holders (A) Fig. 38 are located on the motor housing opposite each other. Remove the brush holder cap (A) Figs. 38

and 39, and remove the brushes for inspection. When the carbon (B) Fig. 39 on either brush is worn to 3/16" or less, or if either

spring or shunt wire (C) is burned or damaged, replace both brushes. If the brushes are found serviceable after removing,

reinstall them in the same position.

DISCONNECT MACHINE FROM POWER SOURCE.

Fig. 38

Fig. 39

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed

air. All plastic parts should be cleaned with a soft damp

cloth. NEVER use solvents to clean plastic parts. They

could possibly dissolve or otherwise damage the material.

Wear ANSI Z87.1 safety glasses while

using compressed air.

FAILURE TO START

Should your machine fail to start, check to make sure the

prongs on the cord plug are making good contact in the

outlet. Also, check for blown fuses or open circuit breakers

in the line.

LUBRICATION

Apply household floor paste wax to the machine table and

extension table or other work surface weekly.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

No comments

Delta 36-322L Instruction Manual Page 22