Delta 36-422L Instruction Manual download pdf (Page 22)

MAINTENANCE

DISCONNECT MACHINE FROM POWER

SOURCE.

CHANGING THE BLADE

NEVER DEPRESS THE SPINDLE LOCK

BUTTON WHILE THE BLADE IS UNDER POWER

OR COASTING. DO NOT CUT FERROUS METAL

(CONTAINING IRON OR STEEL) OR MASONRY OR

FIBER CEMENT PRODUCT WITH THIS MITER SAW.

To remove the blade:

1. Unplug the saw.

2. Raise the arm to the upper position and raise the lower

guard (A) Fig. 36 as far as possible.

3. Loosen, but do not remove guard bracket screw (B)

until the bracket (C) can be raised far enough to access

the blade screw (D). Lower guard will remain raised due

to the position of the guard bracket screw, as shown in

Fig. 37.

4. Depress the spindle lock button (F) Fig. 37A while

carefully rotating the saw blade by hand until the lock

engages.

5. Keeping the button depressed, use the wrench provided

to loosen the blade screw (D). (Turn clockwise, left-

hand threads)

6. Remove the blade screw (D), outer clamp washer (E),

and blade. The 1" (25.4mm) blade adapter, if used, and

the inner clamp washer, may be left on the spindle.

NOTE: For blades with a blade hole of 5/8" (15.88mm), the

1" (25.4mm) blade adapter is not used.

To install the blade:

1. Unplug the saw.

2. With the arm raised and the lower guard held open,

place the blade on the spindle, onto the blade adapter

(if using a blade with a 1" (25.4mm) diameter blade

hole) and against the inner clamp washer. Make sure

the teeth at the bottom of the blade are pointing toward

the back of the saw.

3. Assemble the outer clamp washer onto the spindle.

4. Install the blade screw and, engaging the spindle

lock (F) Fig. 37A, tighten the screw firmly with wrench

provided. (Turn counterclockwise, left-hand threads).

NOTE: When using blades with a 5/8" (15.88mm) diameter

blade hole, the blade adapter will not be used and

should be stored in a safe place for future use.

5. Return the guard bracket to its original position and

firmly tighten the guard bracket screw to hold bracket

in place.

THE GUARD BRACKET MUST BE

RETURNED TO ITS ORIGINAL POSITION AND

THE SCREW TIGHTENED BEFORE ACTIVATING

THE SAW. FAILURE TO DO SO MAY ALLOW THE

GUARD TO CONTACT THE SPINNING SAW BLADE

RESULTING IN DAMAGE TO THE SAW AND SEVERE

PERSONAL INJURY.

Fig. 36

Fig. 37

Fig. 37A

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Comments to this Manuals

No comments

Delta 36-422L Instruction Manual Page 22

Comments to this Manuals

Related products and manuals for Mitre saws Delta 36-422L