Delta MS350 Instruction Manual download pdf (Page 12)

4. If an adjustment is necessary, push in lock handle

(D) Fig 24, and turn counter-clockwise. Loosen lockknob

(B) Fig. 24, and use a 3mm hex wrench to turn screw (C)

until blade is 90 degrees to the table. Tighten lockknob

(B).

5. Raise cuttinghead. Push in and turn lock handle counter-clockwise to loosen.

6. Move the cuttinghead all the way to the left bevel position and tighten lock handle.

7. Use a combination square (A) Fig. 25 to see if the blade is at 45 degrees to the table.

8. If an adjustment is necessary, push in lock handle (D) Fig 26, and turn counter-clockwise. Loosen lockknob (E) Fig.

26, and use a 3mm hex wrench to turn screw (F) until blade is 45 degrees to the table. Tighten lockknob (E). Tighten lock

handle.

These positive stops enable you to rapidly position the blade at the 90 and 45 degree bevel angle to the table.

Fig. 24

Fig. 25

Fig. 26

Fig. 27

ADJUSTING TENSION

OF CUTTINGHEAD

RETURN SPRING

The tension of the cuttinghead return spring has been

adjusted at the factory so that the cuttinghead returns to

the up position after a cut has been made. If it becomes

necessary to adjust the spring tension, proceed as

follows:

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Loosen lockknob (A) Fig. 27 and turn screw (B)

clockwise to increase or counterclockwise to decrease

the spring tension. After the spring tension has been

adjusted, tighten lockknob (A).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Delta MS350 Instruction Manual Page 12