Delta DC-580 20" PLANER 22-450 User Manual download pdf (Page 8)

Fig. 4

Fig. 5

Fig. 6

UNPACKING AND CLEANING

Remove the bolts that fasten the machine to the

shipping skid.

Two lifting lugs are built into the machine, one of which

is shown at (E) Fig. 3. These lugs can be used to

mechanically lift the machine using a forklift and lifting

straps. NOTE: The other lifting lug is located at the rear

and the opposite end of the machine. Carefully remove

the planer from the shipping skid.

Thread handle assembly (A) Fig. 3, into handwheel (B)

and tighten locknut (C).

If it is necessary to lower the table (B) Fig. 4, to facilitate

cleaning, loosen lock knob (C) and turn handwheel (D)

counterclockwise until the table (B) is at the desired

height for cleaning.

With allen wrench supplied, loosen and remove screw

(E) Fig. 5, from the left top edge of the machine and raise

the top cover (F) Fig. 6 as shown, exposing the

chipbreakers, and cutterhead. NOTE: The top cover of

the machine is hinged to facilitate cleaning and

performing maintenance and adjustment procedures.

Carefully remove the protective coating from the table,

table rollers, infeed roller, anti-kickback fingers,

cutterhead and cutterhead knives. This protective

coating may be removed with a soft cloth moistened

with kerosene. (DO NOT USE GASOLINE, ACETONE,

OR LACQUER THINNER FOR THIS PURPOSE).

CAUTION: Extreme care should be taken when

cleaning the knives as the cutterhead knives are

positioned in the cutterhead and are very sharp.

After cleaning, cover the table surface with a good

quality paste wax.

Lower top cover and replace locking screw which was

removed in STEP 5.

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Delta DC-580 20" PLANER 22-450 User Manual Page 8