Delta 50-866 User Manual download pdf (Page 9)

Fig. 19

Fig. 20

Fig. 21

Fig. 22

ASSEMBLING INTAKE PORT

TO MOTOR AND BLOWER

ASSEMBLY

Place the intake port (A) Fig. 19, onto the flange of

motor/blower assembly (B). Align the holes in the flange

(B) of the motor/blower assembly with the mounting

holes in the dust intake port and fasten with four sheet

metal screws (C) as shown in Fig. 20. WARNING:

The blower housing contains a high speed radial

blade that can amputate fingers, grab loose clothing

and neckties, or propel dust at high speeds.

WARNING: NEVER INSERT FINGERS OR ANY

FOREIGN MATTER INTO THE DUST INTAKE PORTS.

ASSEMBLING BAG

SUPPORTS, BAG HANGERS,

AND FILTER BAGS TO

DRUMS

1. Assemble bottom half of threaded lower bag

support (A) Fig. 21, to center of drum assembly (B).

Place a 5/16" lockwasher on a 5/16-18 x 1¼" hex head

screw (C), insert screw (C) up through the bottom of

drum (B), and place special washer (E) (51½mm O.D.

9.8mm I.D. 4mm thick), onto the screw that was inserted

through drum (B). Thread screw (C) into lower bag

support (A) and tighten securely. Bottom half of lower

bag support can be identified by the protrusion “pin” (F)

in the support. Repeat this process for the other drum

assembly.

2. Fig. 22, illustrates the lower bag support assembled

to the drum assembly.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 50-866 User Manual Page 9