Delta 36-325C Instruction Manual download pdf (Page 12)

Fig. 14

Fig. 15

Fig. 16

Fig. 17

ASSEMBLING

GUIDE RAILS

1. Align the three slotted holes in the front guide rail (A)

Fig. 14, with two holes (B) in saw table and slotted hole

to table saw with three 20MM long carriage bolts (D), flat

washers (E), lockwashers (F), and hex nuts (G) as shown

assembled in Fig. 15. NOTE: Do not completely tighten

hardware at this time.

2. Insert longer end of front guide rail extension

connector (H) Fig. 15, into end of guide rail (A).

3. Assemble front guide rail extension (J) Fig. 16, onto

extension connector (H). Align 2 slotted holes in guide

rail extension (J) Fig. 16 with hole (K) in table and slotted

hole (L) in left extension wing (M), and fasten with two

20MM long carriage bolts (D), flat washers (E),

lockwashers (F), and hex nuts (G). NOTE: DO NOT

COMPLETELY TIGHTEN HARDWARE AT THIS TIME.

GUIDE RAIL ADJUSTMENT IS NECESSARY LATER.

4. Fig. 17 illustrates the front guide rail loosely

assembled to the table saw.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Delta 36-325C Instruction Manual Page 12