Delta 36-325C Instruction Manual download pdf (Page 13)

Fig. 18

Fig. 19

Fig. 20

Fig. 21

5. Assemble longer section of rear guide rail (P) Fig. 18,

and shorter section of guide rail (R) to extension wings

and saw table at points (A) with 16MM long hex head

screw (S), two flat washers (T), lockwasher (V), and hex

nut (W); and at points (B) and (C) Fig. 18, with 16MM

long hex head screws (S), lockwasher (V) and one flat

washer (T). NOTE: DO NOT COMPLETELY TIGHTEN

HARDWARE AT THIS TIME. Hardware at point (C)

Fig. 18, will be positioned between guide rails (P) and (R)

as shown in Fig. 19.

6. Using a square (X) Fig. 19, set a depth of 7/16″ on

the scale, place the square (X) at the center and on top

of the saw table. Working toward the two ends of the

rear guide rail, make certain the rear guide rail is parallel

to the saw table, at 7/16″ from the top of the table.

Tighten all mounting hardware as height adjustment is

made to the rear guide rails.

ASSEMBLING RIP FENCE

1. Insert handle (A) Fig. 20 into threaded hole (B) in rip

fence (C).

2. Insert flat head screwdriver into rip fence handle (A)

Fig. 21 and tighten screw (not shown).

Tighten hex nut (D) Fig. 21 against fence body.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

No comments

Delta 36-325C Instruction Manual Page 13